Ic-7800.
![ic-7800. ic-7800.](https://www.wimo.com/media/catalog/product/cache/59b27e4cb9e62ba513991d0529a6e36c/s/p/sp_34_1acc.jpg)
If your radio does not appear in the list, please check with technical support before ordering.
![ic-7800. ic-7800.](https://www.rigpix.com/icom/ic7800_lrg.jpg)
The list of radios given may not be a complete list. While every effort has been made to ensure compatibility of this cable with listed radios, it is not possible for us to physically test with every radio model. It utilizes two separate 32-bit floating point TI DSP chips, has a 7-inch wide. ICOM has followed all the success of the beautiful IC-7800 with the smaller, single receiver IC-7700.
IC 7800. PLUS
If you do not have a RIGblaster Plus II, Plus, DXpro, Pro, or RIGblaster Advantage or your radio does not have FSK input on ACC1, do not order this cable. Description: Description: The ICOM 7700 200W HF/6M has been introduced at the 2007 Dayton Hamvention. The plug labeled "FSK" connects to "Key Out" of the RIGblaster Plus II and Plus, "FSK Out" of the RIGblaster DXpro and Pro, or "CW/FSK" on a RIGblaster Advantage for direct FSK keying of your ICOM radio from Programs that support direct FSK keying such as Hamscope, MMTTY, MixW, etc. The un-labeled mini-plug Provides fixed level audio from the ACC1 connector to the Sound Card Line In for reception of all digital modes. Dynamic microphone that is hard to distort even at high volume, Flat frequency characteristics that make use of the high sound quality of the transceiver. This cable is for ICOM Radios (listed below) that have an 8 pin DIN Accessory (ACC1) connector on the rear panel. RS-232 levels: Elecraft: K2, K3, Icom: 7800, JRC: JST-245 Kenwood TS-480, 570.